Alcatel-Lucent 060321-10, Rev. B, Cli Reference Manual

Page: 1499 / 2354

PIM Commands ipv6 pim candidate-rp
OmniSwitch CLI Reference Guide March 2011 page 23-85
ipv6 pim candidate-rp
Configures the local router as the Candidate-Rendezvous Point (C-RP) for a specified IPv6 multicast
group(s).
ipv6 pim candidate-rp rp_address group_address/prefix_length [priority priority] [interval seconds]
no ipv6 pim candidate-rp rp_address group_address/prefix_length
Syntax Definitions
rp_address Specifies the IPv6 unicast address that will be advertised as a Candi-
date-RP. This must be a domain-wide reachable address.
group_address Specifies the IPv6 multicast group address for which the local router
will advertise itself as a Candidate-RP.
/prefix_length Specifies the prefix length of the specified IPv6 multicast group
address.
priority Specifies the priority value of the Candidate-RP. Values may range
from 0 to 192. The lower the value, the higher the priority.
seconds Specifies the interval at which the C-RP advertisements are sent to the
bootstrap router, in seconds. Values may range from 1 to 300.
Defaults
Platforms Supported
OmniSwitch 10K
Usage Guidelines
•
Use the no form of this command to remove the association of the device as a C-RP for a particular
multicast group.
•
Only one RP address is supported per switch. If multiple candidate-RP entries are defined, they must
specify the same
rp-address.
•
This command is supported only in the sparse mode.
Examples
-> ipv6 pim candidate-rp 2000::1 ff0e::1234/128 priority 100 interval 100
-> no ipv6 pim candidate-rp 2000::1 ff0e::1234/128
parameter default
priority 192
seconds 60