Alcatel-Lucent 060321-10, Rev. B, Cli Reference Manual

Page: 1563 / 2354

QoS Commands qos
OmniSwitch CLI Reference Guide March 2011 page 25-3
qos
Enables or disables QoS. This section describes the base command with a single required option ( enable
or disable ).
In lieu of these options, the base command ( qos ) may be used with other keywords to set up global QoS
configuration. These keywords are listed here and described as separate commands later in this chapter. In
addition, some keywords have a
no form to remove the parameter or return it to its default.
qos {enable | disable}
[trust-ports]
[forward log]
[log console]
[log lines lines]
[log level level]
[stats interval seconds]
[phones [priority priority_value | trusted]]
[user-port {filter | shutdown} {spoof | bgp | bpdu | rip | ospf | vrrp | dvmrp | pim | isis | dhcpserver
| dns-reply}]
Syntax Definitions
enable Enables QoS. The QoS software in the switch classifies flows coming
into the switch to attempt to match them to QoS policies. If a match is
found, the policy parameters are applied to the flow. The
enable setting
may be used alone or in conjunction with optional command keywords.
disable Disables QoS. Flows coming into the switch are not matched to poli-
cies. The
disable setting cannot be used with any other command
keyword.
Defaults
Platforms Supported
OmniSwitch 10K
Usage Guidelines
•
When QoS is disabled, flows coming into the switch are classified but not matched to a policy. Traffic
is treated as best effort and assigned to default queues.
•
The command keywords may be used with or without enable ; these keywords cannot be used with
disable .
Examples
-> qos enable default disposition deny
parameter default
enable | disable enable