YASKAWA CR700, Техническое руководство, Страница: 826 / 886

EZZ023534<1>
12 / 21

S9-19 Wire Length
Sets the wire length in meters from the center of the lifting and lowering shaft drum to the
center of gravity position of the wire tip when the wire is lowered. When using Wire Length
Detection on the lifting and lowering shaft drive, set this parameter so that Wire Length
Detection is 100% output when the hook is lowered. Refer to "3.1 Wire Length Detection" for
more information about Wire Length Detection.
No. Name Setting Range Default Setting
S9-19 Wire Length <1>1.0～300.0m
*1
10.0 m
<1> *1: The setting range is different for different PRG number.
PRG:01017 or later: 1.0 to 300.0 m, earlier than PRG:01017: 1.0 to 50.0 m
S9-14 = 0: Setting value of the wire length.
Sets the wire length from the center of the lifting and lowering shaft drum to the center of
gravity position of the wire tip. The wire length can be changed in steps using S9-28 to S9-
30 [Correction value1 to 3 of Wire Length].
S9-14 = 1: Sets the wire length when the analog input is 100%.
Sets the wire length in meters from the center of the lifting and lowering shaft drum to the
center of gravity position of the wire tip when the wire is lowered to the lowering limit
(reverse travel limit activation) with no cargo suspended. If the center of gravity position of
the wire tip changes due to the condition of the suspended cargo, correct for this using S9-
28 to S9-30 [Correction value1 to 3 of Wire Length].
S9-14 = 2: Sets the wire length when the MEMOBUS input is 100%.
Sets the wire length in meters from the center of the lifting and lowering shaft drum to the
center of gravity position of the wire tip when the wire is lowered to the lowering limit
(reverse travel limit activation) with no cargo suspended. If the center of gravity position of
the wire tip changes due to the condition of the suspended cargo, correct for this using S9-
28 to S9-30 [Correction value1 to 3 of Wire Length].
 S9-20 Wire Length@Rolling Up
This parameter is enabled when Wire Length Detection Method is set to an external input (S9-
14 = 1 or 2).
This parameter sets the wire length in meters from the center of the lifting and lowering shaft
drum to the center of gravity position of the wire tip when the wire is hoisted to the hoisting limit
(forward travel limit activation) with no cargo suspended. When using Wire Length Detection on
the hosting/lowering shaft drive, set this parameter so that Wire Length Detection is 0% output
at the hoisting limit.
S9-14 = 1:
Sets the wire length to S9-20 when the analog input is 0%.
S9-14 = 2: Sets the wire length to S9-20 when the MEMOBUS input is 0%.
No. Name Setting Range Default Setting
S9-20 Wire Length@Rolling Up 1.0 to 50.0 m 1.0 m