YASKAWA CR700, Техническое руководство, Страница: 702 / 886

11.8 H: Terminal Functions
702 YASKAWA SIEPC71061723A YASKAWA AC Drive CR700 Technical Manual
No. Name Default Function
H2-01 Multi-Function Digital Output 1 (contact) 21 Brake Release Command
H2-02 Multi-Function Digital Output 2 (contact) 0 During Run
H2-03 Multi-Function Digital Output 3 (contact) 2 Speed Agree 1
H2-04 Multi-Function Digital Output 4 (open-
collector)
6 Drive Ready
H2-05 Multi-Function Digital Output 5 (open-
collector)
10 Alarm
Refer to the following table when setting
H2-xx [MFDO Function Selection]
.
Table 11.29 MFDO Setting Value
Setting Value Function
0 During Run
1 Zero Speed
2 Speed Agree 1
3 User-Set Speed Agree 1
4 Frequency Detection 1
5 Frequency Detection 2
6 Drive Ready
7 DC Bus Undervoltage
8 During Baseblock (N.O.)
9 Frequency Reference from Keypad
A Run Command from Keypad
B Torque Detection 1 (N.O.)
C Frequency Reference Loss
D Braking Resistor Fault
E Fault
F
*1
Not Used
10 Alarm
11 Fault Reset Command Active
13 Speed Agree 2
14 User-Set Speed Agree 2
15 Frequency Detection 3
16 Frequency Detection 4
17 Torque Detection 1 (N.C.)
18 Torque Detection 2 (N.O.)
19 Torque Detection 2 (N.C.)
1A During Reverse
1B During Baseblock (N.C.)
1C Motor 2 Selection
1D During Regeneration
1F Motor Overload Alarm (oL1)
20 Drive Overheat Pre-Alarm (oH)
Setting Value Function
21 Brake Release Command
22 Overload Detection (N.O.)
23 Weight Det N.C.
2F Maintenance Notification
30 During Torque Limit
33 Zero Servo Complete
37 During Frequency Output
39 Watt Hour Pulse Output
3C LOCAL Control Selected
4C During Fast Stop
4D oH Pre-Alarm Reduction Limit
4E
*2
Braking Transistor Fault (rr)
4F
*2
Braking Resistor Overheat (rH)
51 Safe Torque OFF
52 Warning Signal
60 Internal Cooling Fan Failure
62 Modbus Reg 1 Status Satisfied
63 Modbus Reg 2 Status Satisfied
66 Comparator1
67 Comparator2
69 External Power 24V Supply
6A Data Logger Error
6C Motor Start Speed Warning Signal
B1 DC Injection Braking at Start
B2 DC Injection Braking at Stop
B3 Motor 3 Selection
100 to 1FF
Inverse output of 0 to FF
Generates inverse output of the function
for the selected MFDO. Sets the function
for which to generate inverse output by
specifying the last 2 digits of 1xx (00 to
FF).
*1 Inverse output is not available.
*2 This parameter cannot be set on models 2145 to 2415 and 4075 to 4605.
■
Extended MFDO1 to MFDO3 Function Selection
You can set MFDO functions to bit 0 to bit 2 [MEMOBUS MFDO1 to 3] of MEMOBUS register 15E0 (Hex.).
Use
H2-40 to H2-42 [Mbus Reg 15E0h bit0 to bit2 Output Func]
to select the function.