Rohde & Schwarz R&S UPP, Руководство пользователя

Страница: 842 / 938

Remote Control - Command Description
R&S
®
UPP
826 User Manual 1411.1055.32 ─ 10
TRACe:FFT<n2>:STORe:AY <ay>
TRACe:FFT<n2>:STORe:BY <by>
Commands for saving FFT graph trace data sets.
Commands
...:AX
and
..:BX
are not allowed.
Suffix:
<n2>
.
subsystem number 1 and 2
Parameters:
<by> float
TRACe:WAVeform<n2>:STORe:AY <ay>
TRACe:WAVeform<n2>:STORe:BY <by>
Commands for saving waveform trace data sets.
Commands
...:AX
and
..:BX
are not allowed.
Suffix:
<n2>
.
subsystem number 1
Parameters:
<by> float
7.28 User-definable data buffers
The available data buffers are mainly used for communicating between K1 macros and
IEC/IEEE bus control programs.
The K1 macro or the IEC/IEEE bus control program saves data in the form of strings or
binary data in the available data buffers, from where it can be collected and further pro-
cessed by the other program. However, these buffers can also be used as data buffers
within one of the programs.
●
SYSTem:MEMory:DATA<n3>
on page 826
●
SYSTem:MEMory:FREE
on page 828
●
SYSTem:MEMory:STRing<n3>
on page 828
SYSTem:MEMory:DATA<n3> <data>
Stores up to 1024 data sets with a length limited only by the storage capacity made
available by the operating system. The available storage capacity cannot be deter-
mined exactly but is usually in the range of 128
Mbytes. Preference should be given to
this memory when saving trace data.
User-definable data buffers