Rohde & Schwarz R&S UPP, Руководство пользователя

Страница: 49 / 938

Startup
R&S
®
UPP
33 User Manual 1411.1055.32 ─ 10
●
0: The instrument is disconnected from the AC supply
●
1: The instrument is supplied by the AC supply voltage. Depending on the activa-
tion of the standby mode pushbutton, the instrument is either in standby mode
(POWER LED is yellow) or it is switched on (POWER LED is green)
2.3 Putting into Operation
The following section describes how to put the instrument into operation, connect
external devices such as printer and monitor, and a connection of the audio analyzer
with a network. It contains general safety instructions for instrument operation.
For information about installing options, see Chapter 2.9, "Installing Options" ,
on page 44.
For information about the firmware update, see Chapter 2.11, "Firmware Update" ,
on page 62.
Safety precautions
Be absolutely sure to follow the instructions in the sections below to prevent injury to
people or damage to the instrument. This is particularly important if the instrument is
used for the first time. The general safety instructions at the beginning of this manual
must also be observed.
2.3.1 Unpacking the instrument
The instrument is delivered together with the accessories in one box. Proceed as fol-
lows to unpack its contents:
1. Remove the instrument from its packaging and check the shipment for complete-
ness using the shipping document and the accessory lists for the various items.
2. First, pull off the protective plastic pads from the rear feet of the instrument and
then from the front handles.
3. Remove the protective cover made of corrugated board from the rear of the instru-
ment.
4. Carefully unthread the corrugated cardboard cover at the front that protects the
instrument handles and remove it.
5. Check the instrument for any damage. If there is damage, immediately contact the
carrier who delivered the instrument. In this case, do not discard the box and pack-
aging material.
Putting into Operation