Rohde & Schwarz R&S UPP, Руководство пользователя

Страница: 659 / 938

Remote Control - Fundamentals
R&S
®
UPP
643 User Manual 1411.1055.32 ─ 10
Replace ipaddr by the IP address or the computer name of the instrument. For
instance, if the instrument has the IP address 192.1.2.3, TCPIP::
192.1.2.3::inst0::INSTR is the valid resource name. The specification of
inst0 in the
resource name is optional and may be omitted. So in this example TCPIP::
192.1.2.3::INSTR is also a valid resource name. A resource name with computer name
could be TCPIP::RSUPP1::INSTR.
If LXI is installed, the IP address of the instrument can be determined easily by using a
Web browser. See
Chapter 2.10.3, "Configuration via LXI" , on page 52.
TCPIP designates the network protocol used and INSTR indicates that the VXI-11 pro-
tocol is used. If several instruments are connected to a network, each instrument has
its own IP address and associated resource name. The controller distinguishes these
instruments by their resource name.
In the example below, the Measurement & Automation Explorer program from National
Instruments is used to set up an Ethernet remote control connection. Connection setup
with this program is simple and first tests can be performed. R&S
UPP is ready config-
ured for networks using DHCP (dynamic host configuration protocol). If this configura-
tion is used, the computer name must be entered at the position of the IP address. It is
also possible to assign the R&S
UPP a fixed IP address (see Chapter 2.10, "Connect
R&S UPP to a Network (LAN)" , on page 45).
Configuring the control of R&S UPP in the 'Measurement & Automation Control' pro-
gram.
●
Launch the program on the control computer.
●
Menu "Create new TCP/IP device" with the right mouse key.
●
Enter the IP address of the R&S UPP and select "VXI-11 Instrument" (You can also
enter the computer name).
Changing to Remote Control