Rohde & Schwarz R&S UPP, Руководство пользователя

Страница: 540 / 938

Instrument Functions
R&S
®
UPP
524 User Manual 1411.1055.32 ─ 10
The Reference parameter field is hidden if you select the function measurement result
with Funct Ch1 | Funct Ch2 | Function under Y-source and if an intermodulation mea-
surement is set in the analyzer function panel. Intermodulation measurement results
are measurement results that have already been referenced and cannot be referenced
again.
Available in the graphics subsystems
Sweep, FFT, Waveform, Bar Graph
"Meas Panel" The reference value from the associated measurement function con-
figuration panel is used.
Example:
The additional Input Monitor measurement function is activated in the
analyzer panel:
In the Sweep Graph1 graphic system, the result of the Input Peak
measurement for channel 1 is selected as the source for Trace
A:
The measurement results of the additional Input Monitor Peak mea-
surement function are therefore plotted as Trace A on the Y1-axis.
In the Input Config panel, the reference value for the additional mea-
surement function is set to 0.2222
V.
If Reference is now set to Meas Panel,
the reference value from the Input Config panel is entered here and
used if
referenced units are selected.
In the case of referenced units , this transfer of the reference value
allows the comparison of measured values in the numerical display
field or the combo display with measured values in the graphical dis-
play.
Available in the graphics subsystems
Sweep, FFT, Bar Graph
"Value " A numeric value with unit must be entered as the reference value in
the parameter field below.
Curve, Spectrum and Bar Graph Display