Rohde & Schwarz R&S UPP, Руководство пользователя

Страница: 257 / 938

Instrument Functions
R&S
®
UPP
241 User Manual 1411.1055.32 ─ 10
No of Sine
Used to set the number of sine-wave tones of the multisine
‑
wave signal.
Remote command:
SOURce:MULTisine:COUNt
on page 704
Freq No i
Sets the frequency of the sine wave number i of the multisine
‑
wave signal.
Based on the internal programming, several sine waves of the same frequency cannot
have different phase references. The phase of the first sine wave is set, the phase
information of the other ones is ignored and represented as non-changeable.
Remote command:
SOURce:FREQuency<n2>
on page 697
Phase No i
Used to set the start phase of sine wave number i of the multisine
‑
wave signal. This
parameter field only appears if Define Phase is selected for Crest Factor.
Based on the internal programming, several sine waves of the same frequency cannot
have different phase references. The phase of the first sine wave is set, the phase
information of the other ones is ignored and represented as non-changeable.
Remote command:
SOURce:PHASe<n2>
on page 702
Volt No i
Used to set the voltage of sine wave number i of the multisine
‑
wave signal. The maxi-
mum value depends on the configured DC offset. In the analog generator, the maxi-
mum total voltage also depends on the settings
"Output Type " on page 197 and "Max
Voltage" on page 199 in the Generator Config panel.
Remote command:
SOURce:VOLTage<n2>
on page 699
Total Gain
Used to set a gain factor which can be used to vary the total level of the multisine
‑
wave
signal. The maximum value depends on the configured DC offset. In the analog gener-
ator, the maximum total voltage also depends on the settings
"Output Type "
on page 197 and "Max Voltage" on page 199 in the Generator Config panel.
Remote command:
SOURce:VOLTage:TOTal:GAIN
on page 705
Total Peak
Indicates the peak value of the multi-sine-wave signal.
Remote command:
SOURce:VOLTage:TOTal
on page 704
Total RMS
Indicates the RMS value of the multisine-wave signal (only in the analog generator).
Remote command:
SOURce:VOLTage:RMS
on page 704
Generator Signals