Rohde & Schwarz R&S UPP, Руководство пользователя

Страница: 114 / 938

Getting Started
R&S
®
UPP
98 User Manual 1411.1055.32 ─ 10
c) The "Single" button of the toolbar (single arrow) or "Ctrl F6" of the external key-
board can be used to start the sweep only once ; after the sweep cycle is com-
plete, the status field indicates "Sweep Terminated".
6. Step: Displaying the measurement results – Graphical windows
The results of a frequency response measurement are usually displayed graphi-
cally with the measured output voltage values of the DUT being plotted on the fre-
quency axis.
The following settings are required for this:
a) To avoid overloading screen 1 with too many panels, change to screen 5 to dis-
play the graphical representation.
b) Open the menu bar and, from the selection list under the "DispConfig" button,
select the "Sweep Graph 1 Config" panel. As explained above, the way in
which the measurement results are presented is determined in the configura-
tion panels. Each graphical window has its own configuration panel. The
"Sweep Graph 1 Config" panel required here has two columns, but only Trace
A is shown to provide a better overview.
c) The associated graphical window can be opened using the "Show" button in
the "Display" field. The window appears in the same screen so that the effect of
the following settings can be observed directly.
In each graphical window, one or two traces (Trace A and Trace B) can be plot-
ted on one x
‑
axis. Each trace can consist of a large number of scans. In this
example, only one single scan is to be displayed; the "Scan" field can therefore
remain set to "Single".
Introduction to Instrument Operation Using Examples