Rohde & Schwarz R&S UPP, Руководство пользователя

Страница: 43 / 938

Startup
R&S
®
UPP
27 User Manual 1411.1055.32 ─ 10
[DIGITAL OUT]
Eight outputs in S/P DIF format in accordance with IEC 60958 (Unbal), which are
brought out to a 9
‑
pin D
‑
Sub socket.
As an accessory for the R&S UPP
‑
B8 option (multichannel audio generator), a break-
out cable with a 9
‑
pin D
‑
Sub connector on the one end and five XLR connectors on the
other end is available (R&S UP
‑
Z8D option; refer to data sheet for the order number).
2.1.5 Analog Audio Interfaces
Output and input connectors (XLR) of analog generator and analyzer.
Figure 2-2: R&S UPP variants from top to bottom: R&S UPP 800, R&S UPP 400, R&S UPP 200
Damage to the instrument
The instrument complies with measuring category I; make sure that the input voltage at
the sockets of the analog analyzers does not exceed 50 V (RMS, sine wave) and 70 V
(peak value).
Do not use the instrument in measuring categories II, III and IV.
Explanation: Measuring circuits as defined in section 6.7.4 of EN61010-1: Measuring
category I is intended for measurements on circuits which are not connected to the
high-voltage current system.
[ANALOG OUT 1 / 2]
Two-channel generator signal at XLR connectors
[Analog IN 1 / 2 / 3 / 4 / 5 / 6 / 7 / 8]
Depending on the R&S UPP variant 2, 4 or 8, analog XLR sockets as measurement
inputs
Description of the Front View