Power Over Ethernet Commands
ExtremeWare XOS 11.5 supports only the Summit X450 family of switches and the BlackDiamond 8800 series switch.
ExtremeWare XOS 11.5 Command Reference Guide
534
show inline-power
show inline-power
Description
Displays inline power status information for the system.
Syntax Description
This command has no arguments or variables.
Default
N/A.
Usage Guidelines
The output indicates the following inline power status information for the system:
●
Configured inline power status—The status of the inline power for the switch: enabled or disabled.
●
System power surplus—The surplus amount of power on the system, in watts, available for
budgeting.
●
Redundant power surplus—The amount of power on the system, in watts, available for budgeting if
one power supply is lost.
●
System power usage threshold—The configured power usage threshold for each slot, shown as a
percentage of budgeted power. Once this threshold has been passed on any slot, the system sends an
SNMP alarm and logs a message.
●
Disconnect precedence—The method of denying power to PDs if the budgeted power on any slot is
exceeded.
●
Legacy mode—The status of the legacy mode, which allows detection of non-standard PDs.
The output indicates the following inline power status information for each slot:
●
Inline power status—The status of inline power. The status conditions are:
■
Enabled
■
Disabled
●
Firmware status—The operational status of the slot. The status conditions are:
■
Operational
■
Not operational
■
Disabled
■
Subsystem failure
■
Card not present
■
Slot disabled
●
Budgeted power—The amount of power, in watts, that is reserved and available to the slot.
●
Measured power—The amount of power, in watts, that currently being used by the slot.
