Commands for Status Monitoring and Statistics
ExtremeWare XOS 11.5 supports only the Summit X450 family of switches and the BlackDiamond 8800 series switch.
ExtremeWare XOS 11.5 Command Reference Guide
614
Displaying the Module Recovery Setting.
To display the module recovery setting, use the following
command:
show slot
Beginning with ExtremeWare XOS 11.5, the
show slot
output has been modified to include the
shutdown configuration. If you configure the module recovery setting to shutdown, the output displays
an “E” flag that indicates any errors detected on the slot disables all ports on the slot. The “E” flag
appears only if you configure the module recovery setting to shutdown.
NOTE
If you configure one or more slots for shut down and the switch detects a hardware fault on one of those slots, all of
the configured slots enter the shutdown state and remain in that state until explicitly cleared.
If you configure the module recovery setting to none, the output displays an “e” flag that indicates no
corrective actions will occur for the specified MSM or I/O module. The “e” flag appears only if you
configure the module recovery setting to none.
The following sample output displays the module recovery action. In this example, notice the flags
identified for slot 10:
Slots Type Configured State Ports Flags
-------------------------------------------------------------------------------
Slot-1 G48P G48P Operational 48 MB S
Slot-2 G24X G24X Operational 24 MB S
Slot-3 G48T G48T Operational 48 MB S
Slot-4 Empty 0
Slot-5 G8X G8X Operational 8 MB S
Slot-6 G8X G8X Operational 8 MB S
Slot-7 Empty 0
Slot-8 G48Te G48Te Operational 48 MB S
Slot-9 G48Ta Operational 48 MB S
Slot-10 G48Pe G48Pe Operational 48 MB S E
MSM-A MSM-G8X Operational 0 S
MSM-B MSM-G8X Operational 0 S
Flags : M - Backplane link to Master MSM is Active
B - Backplane link to Backup MSM is also Active
I/O Module
Reboots the I/O module. When the module
comes up, the ports remain inactive
because you must clear the shutdown
state using the
clear sys-recovery-
level
command for the I/O module to
become operational.
After you clear the shutdown state, you
must reset each affected I/O module or
reboot the switch.
For more information see the
clear
sys-recovery-level
command.
Table 17: Module recovery actions for the BlackDiamond 10808 and the BlackDiamond 12804
switches (Continued)
Module Recovery Setting
System Recovery Setting
Hardware
Action Taken
