show ports statistics
ExtremeWare XOS 11.5 supports only the Summit X450 family of switches and the BlackDiamond 8800 series switch.
ExtremeWare XOS 11.5 Command Reference Guide
691
●
Received Packet Count (Rx Pkt Count)—The total number of good packets that have been received
by the port.
●
Received Byte Count (RX Byte Count)—The total number of bytes that were received by the port,
including bad or lost frames. This number includes bytes contained in the Frame Check Sequence
(FCS), but excludes bytes in the preamble.
●
Received Broadcast (RX Bcast)—The total number of frames received by the port that are addressed
to a broadcast address.
●
Received Multicast (RX Mcast)—The total number of frames received by the port that are addressed
to a multicast address.
Port Monitoring Display Keys.
Table 19
describes the keys used to control the display that appears if auto-
refresh is enabled (the default behavior).
Table 20
describes the keys used to control the display that appears if you auto-refresh is disabled.
Example
The following command displays port statistics for slot 1, ports 1 through 2 on a modular switch with
auto-refresh disabled:
show ports 1:1-1:2 statistics no-refresh
The following is sample output from this command:
Port Statistics
Port Link Tx Pkt Tx Byte Rx Pkt Rx Byte Rx Rx
Status Count Count Count Count Bcast Mcast
================================================================================
1:1 A 7241 2722608 14482 3968068 0 0
1:2 R 0 0 0 0 0 0
================================================================================
Link Status: A-Active, R-Ready, NP-Port not present
The following command displays port statistics for all ports on the Summit X450 family of switches
with auto-refresh enabled (the default behavior):
show ports statistics
Table 19: Port monitoring display keys with auto-refresh enabled
Key(s)
Description
U
Displays the previous page of ports.
D
Displays the next page of ports.
[Esc]
Exits from the screen.
0
Clears all counters.
Table 20: Port monitoring displays keys with auto-refresh disabled
Key
Description
Q
Exits from the screen.
[Space]
Displays the next page of ports.
