unconfigure eaps port
ExtremeWare XOS 11.5 supports only the Summit X450 family of switches and the BlackDiamond 8800 series switch.
ExtremeWare XOS 11.5 Command Reference Guide
1161
unconfigure eaps port
unconfigure eaps <eapsDomain> [primary | secondary] port
Description
Sets the specified port’s internal configuration state to INVALID.
Syntax Description
Default
N/A.
Usage Guidelines
Unconfiguring an EAPS port sets its internal configuration state to INVALID, which causes the port to
appear in the Idle state with a port status of Unknown when you use the
show eaps detail
command
to display the status information about the port.
To prevent loops in the network, the switch displays by default a warning message and prompts you to
unconfigure the specified EAPS primary or secondary ring port. When prompted, do one of the
following:
●
Enter
y
to unconfigure the specified port.
●
Enter
n
or press [Return] to cancel this action.
If you have considerable knowledge and experience with EAPS, you might find the EAPS loop
protection warning messages unnecessary. For more information, see the
configure eaps config-
warnings off
command
on page 1117
.
Example
The following command unconfigures this node’s EAPS primary ring port on the domain eaps_1:
unconfigure eaps eaps_1 primary port
The switch displays the following warning message and prompts you to confirm this action:
WARNING: Unconfiguring the Primary port from the EAPS domain could cause a loop in
the network!
Are you sure you want to unconfigure the Primary EAPS Port? (y/n)
Enter
y
to continue and unconfigure the EAPS primary ring port. Enter
n
to cancel this action.
The switch displays a similar warning message if you unconfigure the secondary EAPS port.
eapsDomain
Specifies the name of an EAPS domain.
primary
Specifies that the primary port should be unconfigured.
secondary
Specifies that the secondary port should be unconfigured.
