BGP Commands
ExtremeWare XOS 11.5 supports only the Summit X450 family of switches and the BlackDiamond 8800 series switch.
ExtremeWare XOS 11.5 Command Reference Guide
1694
configure bgp neighbor peer-group
configure bgp neighbor [all | <remoteaddr>] peer-group [<peer-group-name> |
none] {acquire-all}
Description
Configures an existing neighbor as the member of a peer group.
Syntax Description
Default
By default, remote AS (if configured for the peer group), source-interface, outbound route policy, send-
community and next-hop-self settings are inherited.
Usage Guidelines
If
acquire-all
is not specified, only the default parameters are inherited by the neighbor.
When you remove a neighbor from a peer group, it retains the parameter settings of the group. The
parameter values are not reset to those the neighbor had before it inherited the peer group values.
To create a new neighbor and add it to a BGP peer group, use the following command:
create bgp neighbor <remoteaddr> peer-group <peer-group-name> {multi-hop}
The new neighbor is created as part of the peer group and inherits all of the existing parameters of the
peer group. The peer group must have remote AS configured.
Example
The following command configures an existing neighbor as the member of the peer group
outer
:
configure bgp neighbor 192.1.1.22 peer-group outer
History
This command was first available in ExtremeWare XOS 10.1.
This command required an Advanced Core license in ExtremeWare XOS 11.1.
all
Specifies all neighbors.
remoteaddr
Specifies an IP address of a BGP neighbor.
peer-group-name
Specifies a peer group name.
none
Removes the neighbor from the peer group.
acquire-all
Specifies that all parameters should be inherited by the neighbor from the peer
group.
