BGP Commands
ExtremeWare XOS 11.5 supports only the Summit X450 family of switches and the BlackDiamond 8800 series switch.
ExtremeWare XOS 11.5 Command Reference Guide
1688
configure bgp neighbor maximum-prefix
configure bgp neighbor [<remoteaddr> | all] {address-family [ipv4-unicast |
ipv4-multicast]} maximum-prefix <number> {{threshold <percent>} {teardown
{holddown-interval <seconds>}} {send-traps}
Description
Configures the maximum number of IP prefixes accepted from a BGP neighbor.
Syntax Description
Default
This feature is disabled by default.
The default threshold is 75%.
By default,
teardown
is not specified.
By default,
send-traps
is not specified.
If no address family is specified, IPv4 unicast is the default.
Usage Guidelines
Configure the peer group before configuring the neighbors. To configure the peer group, use the
following command:
configure bgp peer-group maximum-prefix
remoteaddr
Specifies an IP address of a BGP neighbor.
all
Specifies all neighbors.
address-family
The address family. BGP supports two address families: IPv4 Unicast and IPv4
Multicast.
number
Specifies the maximum number of prefixes that can be accepted. The range is
0 to 4294967294. A value of 0 disables prefix limit feature.
percent
Specifies the percentage of the maximum prefix (threshold) at which a warning
message is printed in the log (and console), and/or a trap will be sent to the
SNMP manager.
teardown
Specifies that the peer session is torn down when the maximum is exceeded.
seconds
Specifies the length of time before the session is re-established, if the session
is torn down due to maximum prefix exceeded. If the hold-down interval is zero
or not specified, it is kept down until the peer is enabled. The range is 30 to
86400 seconds.
send-traps
Specifies sending “number of prefix reached threshold” and “number of prefix
exceed the max-prefix limit” SNMP traps.
