configure inline-power priority ports
ExtremeWare XOS 11.5 supports only the Summit X450 family of switches and the BlackDiamond 8800 series switch.
ExtremeWare XOS 11.5 Command Reference Guide
517
configure inline-power priority ports
configure inline-power priority [critical | high | low] ports <port_list>
Description
Sets the PoE priority on the specified ports on a modular switch.
Syntax Description
Default
Low.
Usage Guidelines
The system allocates power to those ports with the highest priorities first on a modular switch. This
command can also be used in conjunction with the
configure inline-power disconnect-precedence
command. If you configure the disconnect precedence as lowest priority, then newly detected PDs will
be powered if that port has higher priority than the existing powered ports.
If there are multiple ports at the same priority level (either configured, or by default) and one of the
ports must have power withdrawn because of excessive power demands, those ports with the lower
port number are powered first. The higher port numbers have power withdrawn first in the case of
equal PoE port priorities.
Example
The following command assigns a critical PoE priority on ports 4 – 6 on slot 3:
configure inline-power priority critical ports 3:4-3:6
History
This command was first available in ExtremeWare XOS 11.1.
Platform Availability
This command is available on the G48P and G48Pe modules installed in the BlackDiamond 8800 series
switch.
critical | high | low
Sets the PoE priority for the specified ports.
port_list
Specifies one or more slots and ports.
