configure eaps port
ExtremeWare XOS 11.5 supports only the Summit X450 family of switches and the BlackDiamond 8800 series switch.
ExtremeWare XOS 11.5 Command Reference Guide
1135
Enter
y
to add the ports to the VLAN. Enter
n
or press [Return] to cancel this action.
If you see this message, either configure the VLAN as an EAPS protected VLAN by using the
configure eaps add protected vlan
command or add ports that the EAPS domain does not use as
primary or secondary ring ports.
If you have considerable knowledge and experience with EAPS, you might find the EAPS loop
protection warning messages unnecessary. For more information, see the
configure eaps config-
warnings off
command
on page 1117
.
Example
The following command adds port 1 of the module installed in slot 8 to the EAPS domain “eaps_1” as
the primary port:
configure eaps eaps_1 primary port 8:1
History
This command was first available in ExtremeWare XOS 11.0.
Platform Availability
This command is available on all platforms.
