Configuration and Image Commands
ExtremeWare XOS 11.5 supports only the Summit X450 family of switches and the BlackDiamond 8800 series switch.
ExtremeWare XOS 11.5 Command Reference Guide
1910
install bootrom
install bootrom <fname> {reboot} {msm <slotid>}
Description
Installs a new version of the ExtremeWare XOS BootROM image on the Summit X450 family switch or
the BlackDiamond 10808 switch.
Syntax Description
Default
N/A.
Usage Guidelines
When you download a BootROM image, the system asks if you want to install the image immediately
after the download is finished. If you choose to install the image at a later time, use this command to
install the software on the switch.
The BootROM image file is a .xbr file, and this file contains the executable code.
Displaying the BootROM Versions.
To display the BootROM version for the switch and all of the modules
and PSU controllers installed in a modular switch, use the
show version
command.
Local Filename Character Restrictions.
This section provides information about the characters supported
by the switch for local and remote filenames.
When specifying a local or remote filename, the switch permits only the following characters:
●
Alphabetical letters, upper case and lower case (A-Z, a-z)
●
Numerals (0-9)
●
Period ( . )
●
Dash ( - )
●
Underscore ( _ )
When naming a local file, remember the requirements listed above.
fname
Specifies the BootROM image file.
reboot
Reboots the switch after the image is installed.
msm
Specifies the MSM where the BootROM image should be installed.
• A specifies the MSM installed in slot A.
• B specifies the MSM installed in slot B.
NOTE: This parameter is available only on the BlackDiamond 10808 switch.