Troubleshooting Commands
ExtremeWare XOS 11.5 supports only the Summit X450 family of switches and the BlackDiamond 8800 series switch.
ExtremeWare XOS 11.5 Command Reference Guide
1970
Summit X450 family switch example
The following command runs normal diagnostics on the Summit X450 family switch:
run diagnostics normal
The switch displays a warning similar to the following about the impact of this test. You also have the
opportunity to continue or cancel the test:
Running Diagnostics will disrupt network traffic.
Are you sure you want to continue? (y/n)
Enter
y
to continue and run the diagnostics. Enter
n
to cancel the operation.
The following command runs diagnostics on the stack ports on the Summit X450 family switch:
run diagnostics stack-port
If you issue this command with a console connection, the switch displays the following information.
You also have the opportunity to continue or cancel the test:
Summit Diagnostics Mode Enabled, Starting Diagnostics....
Found X450a-24T in Motherboard
Motherboard CPLD Revision: 2
Starting stacking port diagnostics
*****************************************************************
* *
* Please connect a cable between Stack Port 1 and Stack Port 2. *
* *
* Press S to skip test, ENTER key to continue. *
* *
*****************************************************************
Press [Enter] to continue and run the diagnostics. Enter
S
to cancel the operation.
If you continue with diagnostics, the switch displays messages similar to the following:
Stack Port 1 and Stack Port 2 BERT
......................................................................................
..............
...................................................................................
Stacking ports
Port 1 (Device 0 - Device port 26)
Lane 0 PASSED.
Lane 1 PASSED.
Lane 2 PASSED.
Lane 3 PASSED.
Port 2 (Device 0 - Device port 27)
Lane 0 PASSED.
Lane 1 PASSED.
Lane 2 PASSED.
