Hioki Power HiTester 3193, Instruction Manual

Page: 82 / 310

64
────────────────────────────────────────────────────
6.1 Hold Function
────────────────────────────────────────────────────
NOTE
Time
Hold Hold
Update
Update
Start holding Update
Release holding
Display value
Display
value
Hold
Update
HOLD
SHIFT
HOLD Lo Lo
･ In the hold state, it is not possible to change settings.
･
In the auto-ranging, the range when the
HOLD
key is pressed is fixed.
･
In the hold state, external output values (for floppy disk or printer, through
the GP-IB or RS-232C interface, or D/A output) are the values displayed on
the screen. When combined with the interval timer, the display is updated at
the specified interval. In this case the previous value is held until the next
interval time.
･
For timer and real-time control, the display is updated at the stop time, and
then held.
･
The HOLD key operates at any time, including prior to and during timer
operation.
Combination with external control signal
When the unit is in the held state, the display can be held or updated using
an external control signal to the EXT. A/D START terminal of the OUT
(ANALOG WAVE D/A), EXT. CONT connector on the rear panel.