Hioki Power HiTester 3193, Instruction Manual

Page: 228 / 310

210
────────────────────────────────────────────────────
12.5 Command Summary
────────────────────────────────────────────────────
12.5.5 Execution Time of GP-IB Interface Command
NOTE
Commands Executing time
*
RST
Within 1 s
:MEASure? (when 16 data) Within 20 ms
:DEMAg? (for 1 channel)
Within 7 s
:MODE
Within 500 ms
:COUPling(ch)
:CURRent(ch):RANGe
:CURRent(ch):MEAN
:EXTernal(ch):RANGe
:FREQuency(ch):RANGe
:LPF(ch)
:PHF(ch)
:RESPonse
:VOLTage(ch):RANGe
:VOLTage(ch):MEAN
:WAVEpeak(ch)
Within 30 ms
*
TST? 10 s
Commands other than in the table
above
Within 20 ms
Execution time
Displays the analysis and dealing time of long form command.
However for commands with parameter data, the time is that for the case
determined by the data format specified by the data item, and for queries the
time is that with headers enabled.
･
With the exception of the following, all this unit commands and queries are
of the overlap type.
*OPC *OPC?
*RST *WAI
*TST? *TRG
:STARt :STOP
:INTEGrate:STARt :INTEGrate:STOP
:INTEGrate:RESEt :HOLD
:PEAKhold
･
When communicates with controller, it is necessary to add the data transfer
time. However, the transfer time of GP-IB differs according to controller
type.
The transfer time of the data for RS-232C is as follows, when the data
length is set to 8, parity is Even, stop bit is 1 (total number of the data is
10).
9600 bit/second 960 character/second
2400 bit/second 240 character/second
･
Commands for setting needs some waiting time until stabilizing
measurement after changing them.