Hioki Power HiTester 3193, Instruction Manual

Page: 122 / 310

104
────────────────────────────────────────────────────
11.8 Saving the Data on FDD
────────────────────────────────────────────────────
11.8.5 Saving and Loading Settings
118-1.tif change
F1 F5
Configuration File
NOTE
F1 F2
Files
F1 F2 F3 F4 F5
NOTE
By saving the current settings of the unit and reloading them later, the
current state can be restored.
Saving the Settings
1. Insert the floppy disk into the unit.
2. Press the
FDD
key to display the FDD screen.
3. Using the CURSOR keys, move the cursor to
"
Configuration File
".
4. Press the
F1
(Set)
to enter the setting mode.
Make a setting referring to Section 11.6.
5. After settings, press the
F5
(Confirm)
key to
complete setting.
6. Press the
F5
(Save)
key to save the settings.
If a file of the specified name already exists on the floppy disk, the file is
automatically saved as another name. If the file name is not specified, it is
saved in the same way.
Loading and Deleting Settings
1. Insert the floppy disk to be loaded into the floppy
disk drive.
2. Press the FDD key to display the FDD screen.
3. Using the
CURSOR
keys, move the cursor to "
Files
".
4. Press the
F1
(
Config.)
key to display the
configuration files of the floppy disk.
5. Using the
F1
(↑)
and
F2
(↓)
keys
,
move the
cursor to the file name to be loaded.
6. Press the
F3
(Load)
key
.
The following message is displayed.
"Loading configuration file"
F1
(Yes)
: loads settings and executes unit setting
again.
F2
(No)
: does not execute.
To restore the settings of the unit, the option
configuration must be unchanged. If any aspect of the
configuration has changed the reload will not be
possible.