Hioki Power HiTester 3193, Instruction Manual

Page: 203 / 310

185
────────────────────────────────────────────────────
:SCALe [channel no.] :CONTrol?
────────────────────────────────────────────────────
Syntax
:SCALe
[1 - 6]
:CONTrol?
Response
syntax
:SCALE:[
1-6
]:CONTROL
<ON/OFF>,
<ON/OFF>,<ON/OFF>
Example
Transmission
Response
:SCALE1:CONTROL?
:SCALE1:CONTROL ON,ON,OFF
Syntax
:SCALe
[1 - 6]
:CT
<NR2>
<NR2> = 0.0001 to 10000
Example
:SCALE1:CT 1000
Sets the CT ratio for channel 1 to
1000.
Syntax
:SCALe
[1 - 6]
:CT?
Response
syntax
:SCALE
[1-6]
:CT
<0.0001-10000>
Example
Transmission
Response
:SCALE1:CT?
:SCALE1:CT 1000
Function
Queries the current setting of scaling
function for specified input unit.
Function
Sets the CT ratio for the specified input
unit.
Notes
･ Specifying a value which cannot be
selected because of the number of input
units installed results in an execution
error.
･ In 1P3W mode or above, for the channel
specification, enter the number of the
lowest-numbered channel in the
combination. For example, when using
input unit channels 1 to 3 in 3V3A
mode, specify "1". The channels in
combination can not be set individually.
･
Unless the :SCALe[channel no.]
:CONTrol command is set to ON, this
setting is invalid even if the CT ratio is
set.
･
When using the 9602 and CT6862
together, please set 2.5, the default CT
ratio or the value calculated by the
formula: ((the desired CT ratio)
× 2.5).
For example, when you want to set 40 as
CT ratio, please set 100 (=40
× 2.5).
Function
Queries the current setting of CT ratio for
the specified input unit.
:SCALe [
channel no.
] :CONTrol?
Queries the setting of scaling function of PT, CT, SC ratios.
:SCALe [
channel no.
] :CT
Sets the CT ratio.
:SCALe [
channel no.
] :CT?
Queries the CT ratio.