Hioki Power HiTester 3193, Instruction Manual

Page: 107 / 310

89
────────────────────────────────────────────────────
9.3 Internal Circuit for the External Control and Timing
────────────────────────────────────────────────────
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
9.3.2 FDD/PRINTER.START Terminal
5 V
(open-circuit)
0 V
(short-circuit)
Using the printer: repeat 10 seconds or more
Using the FDD: repeat 1 minute or more
at least 300 ms
NOTE
9.3.3 EXT.A/D START Terminal
5 V
(open-circuit)
0 V
(short-circuit)
Repeat 200 ms or more
at least 10 ms
Update during this time
This terminal controls starting of floppy disk and printer output.
･
This signal is ignored when automatic output is activated.
･
It is not possible to separately control writing to floppy disk and printer.
･ When writing to the floppy disk, if no file name is specified, a file name is
allocated automatically.
When the display screen is held, this updates the display. In the peak hold
state, the maximum value is reset at this point, and the peak hold operation
begins again.