Hioki Power HiTester 3193, Instruction Manual

Page: 87 / 310

69
────────────────────────────────────────────────────
7.2 Setting the Control Time
────────────────────────────────────────────────────
1
2
3
4
5
6
7
8
9
10
11
12
13
14
A
NOTE
7.2.1 Setting the Interval Time
F1 F2
F1 F2
TIME
INTERVAL
TIME
7.2 Setting the Control Time
Using the three time control functions provided by this unit, it is possible to
control time averaging, the floppy disk drive, printer, and integration
functions.
･
It is not possible to make separate settings for time averaging, floppy disk
drive, printer, and integration functions.
･
The integration function always operates. Therefore, even when the
integration value is not being measured, during the operation period of time
control, the "
INTEG
" indication appears. After end of time control, reset
(
SHIFT → START/STOP
) to turn off the "
INTEG
" display.
･
When using time averaging integration, some settings are disabled. If auto
ranging is set, the range is fixed at the start time. The HOLD function,
however, can still be used.
･
Even when time settings are made, the unit does not operate until the panel
START/STOP
key is pressed.
･ The operation starts by real-time control and it is completed by timer
control. In this case, the stop time by real-time control is ignored.
Interval control operates the unit repeatedly at the specified interval.
1. Press the
STATUS
key, then use the
PAGE
( )
keys to display the "
TIME
" (time control) page.
2. Using the CURSOR keys, move the cursor to the
" INTERVAL " and press
F2
to set to ON.
3. Move the cursor to desired time digit, and set the
time using the
F1
(↑)
and
F2
(
↓
).
4. After setting completed, press the MEAS key to
return to the measurement screen.
5. Press the
START/STOP
key to start operation.
411-1.tif 411-2.tif CHANGE