Hioki Power HiTester 3193, Instruction Manual

Page: 144 / 310

126
────────────────────────────────────────────────────
12.3 Interface Outline
────────────────────────────────────────────────────
Event status register 1 (ESR1)
Bit 7
Unused
Bit 6
O6
Channel 6 out of range
Indicates summary of ESR16, which shows the out-of-range
for channel 6 input unit.
Bit 5
O5
Channel 5 out of range
Indicates summary of ESR15, which shows the out-of-range
for channel 5 input unit.
Bit 4
O4
Channel 4 out of range
Indicates summary of ESR14, which shows the out-of-range
for channel 4 input unit.
Bit 3
O3
Channel 3 out of range
Indicates summary of ESR13, which shows the out-of-range
for channel 3 input unit.
Bit 2
O2
Channel 2 out of range
Indicates summary of ESR12, which shows the out-of-range
for channel 2 input unit.
Bit 1
O1
Channel 1 out of range
Indicates summary of ESR11, which shows the out-of-range
for channel 1 input unit.
Bit 0
OF
Frequency input over
Indicates summary of ESRF, which shows the out-of-range
of frequency.
(5) Event status registers 1 (ESR1)
This register is used to monitor the input units for out of range values.
Bits 1 to 6 correspond to channels 1 to 6.
The bits are summaries of the event status registers 11 to 16 (ESR11 to
ESR16), which show the out-of-range information for each input unit.
The bit 0 is summary of the event status register F (ESRF), which shows the
out-of-range information for frequency.
The following commands are used for reading the event status register 0, and
for setting the event status enable register 1 and for reading it.
Reading event status register 1 *ESR1?
Setting event status enable register 1 *ESE1
Reading event status enable register 1 *ESE1?