Hioki Power HiTester 3193, Instruction Manual

Page: 280 / 310

262
────────────────────────────────────────────────────
18.2 Disposing of the Unit
────────────────────────────────────────────────────
WARNING
To avoid electric shock when removing the battery, disconnect the
input cable, clamp on sensor and power cord.
Do not short-circuit used batteries, disassemble them, or throw them
in a fire. Doing so may cause the batteries to explode.
Keep used batteries out of the reach of children. Dispose of used
batteries according to their type in the prescribed manner and in the
proper location.
Fixing plate
Top cover
Lithium battery
Front panel
CPU board
Cable
CALIFORNIA, USA ONLY
This product contains a CR Coin Lithium Battery which contains Perchlorate Material - special handling may apply.
See www.dtsc.ca.gov/hazardouswaste/perchlorate
18.2 Disposing of the Unit
This unit uses a lithium battery for memory backup. Remove the lithium
battery before disposing of the power meter, and follow the prescribed
method when disposing of the unit.
(1) Tools required for disassembly
The following tools are required in order to disassemble this unit:
・
One Phillips screwdriver
・
One pair of wire cutters
(2) Disassembly
1. As shown in the figure left, remove the
supporting foot at the rear, and slide off the
top cover.
2. Remove the fixing plate.
3. Remove the front panel and cable, and then
remove the CPU board.
4. As shown in the figure on the left, the
lithium battery is on the board; cut the two
leads with nippers, and remove from the
board.