Hioki Power HiTester 3193, Instruction Manual

Page: 104 / 310

86
────────────────────────────────────────────────────
9.1 Connector Pin Arrangement
────────────────────────────────────────────────────
1 U 1 analog output 26 U 4 analog output
2
I
1 analog output 27
I
4 analog output
3 P 1 analog output 28 P 4 analog output
4
U
1 monitor output 29
U
4 monitor output
5 I 1 monitor output 30 I 4 monitor output
6
U
2 analog output 31
U
5 analog output
7 I 2 analog output 32 I 5 analog output
8
P
2 analog output 33
P
5 analog output
9
U
2 monitor output 34
U
5 monitor output
10
I
2 monitor output 35
I
5 monitor output
11
U
3 analog output 36
U
6 analog output
12
I
3 analog output 37
I
6 analog output
13
P
3 analog output 38
P
6 analog output
14
U
3 monitor output 39
U
6 monitor output
15
I
3 monitor output 40
I
6 monitor output
16 Va monitor output (9603chA) 41 Vb monitor output (9603chB)
17 D/A1 42 D/A5
18 D/A2 43 D/A6
19 D/A3 44 D/A7
20 D/A4 45 D/A8
21 Analog GND 46 Analog GND
22 INTEG. EXT. CONT 47 Digital GND
23 INTEG. RESET 48 for the 9605
24 FDD/PRINTER.START 49 for the 9605
25 EXT. A/D ATART 50 for the 9605
NOTE
9.1 Connector Pin Arrangement
The pin arrangement of the terminals (ANALOG OUT D/A OUT,
EXT.CONT) on the rear panel is shown below.
･
The analog ground serves for the input unit outputs and D/A outputs.
･
The digital ground serves for the control signals .
･ Outputs from the input units are not output if the corresponding input unit is
not installed. The line goes open-circuit.
･ For the analog output voltage values and monitor output voltage values, refer
to the specifications for the particular input unit.
･
For combinations 1P3W and above, there is no analog output of the sum
value. If required, use the D/A output.
･
For details of pin 48, pin 49, and pin 50, refer to the documentation supplied
with the 9605 harmonic analysis/flicker measurement unit.