Hioki Power HiTester 3193, Instruction Manual

Page: 88 / 310

70
────────────────────────────────────────────────────
7.2 Setting the Control Time
────────────────────────────────────────────────────
NOTE
7.2.2 Setting the Timer
F1 F2
TIME
TIMER
NOTE
･ The interval setting is in steps of 10 seconds, to a maximum of 100 hours 00
minutes 00 seconds.
･
Even when operated without the timer or real-time control time set, the timer
operates at 10,000 hours. For this reason, once 10,000 hours have elapsed,
pressing the
START/STOP
key does not operate the unit.
In this case, press the SHIFT and START/STOP keys to reset.
･
If the interval timer setting is longer than the time set by the timer or real-
time control function start/stop setting, then the interval setting has no effect.
･
If the timing at which timer or real-time control ends does not coincide with
the timing of the interval timer, the timing of timer or real-time control takes
precedence and the unit stops.
･
When operating in conjunction with the floppy disk drive, or printer, the
minimum setting of the interval timer changes, according to the amount of
data being written. See Chapter 11, "Using the Floppy Disk Drive.",Chapter
13, "Using the Printer (Option)."
Timer control provides a single time interval. This can also be used in
combination with the interval time, to subdivide the timer time.
1. Set the timer time in the same way of the interval
time setting.
2. Press the MEAS key to return to the measurement
screen.
3. Press the
START/STOP
key to start operation and
stop automatically the control after timer time.
During operation, "
INTEG
" is displayed.
4. To stop operation, press the START/STOP key
again.
411-3.TIF CHANGE
･ The timer time setting is in steps of 1 minute, to a maximum of 10000
hours.
･ Even if the real-time control function is enabled, The operation starts by
start time, and it is completed by timer control. In this case, the stop time is
ignored.