Renault Laguna III, Manual

Page: 473 / 3699

11A
-
95
TOP AND FRONT OF ENGINE
Timing chain: Removal - Refitting
M9R
11A
a
Engage the collet ( 34 ) of the tool (Mot. 1769) ( 33 )
into the camshaft groove.
a
Turn the tool to align the shafts on the spacer ( 35 )
and the hole ( 36 ) .
a
Detach the collet ( 34 ) of the tool from the camshaft
groove.
a
Fit the pins ( 37 ) of the tool into the wear compensa-
tion pinion holes.
a
Turn the tool to align the shafts on the spacer ( 35 )
and the hole ( 36 ) .
a
Fit the collet ( 34 ) of the tool into the groove on the
camshaft, without forcing it (if necessary, start the
previous operations again).
a
Fit the bolt ( 38 ) (M6 - 50 mm long) onto the tool.
a
Torque tighten the timing sprocket bolts on the
exhaust side of the camshaft (10 N.m + 40˚
± ± ± ±
6˚) .
a
Remove:
- the bolt ( 38 ) ,
- the (Mot. 1769) ,
- the tool (Mot. 1766) (TDC locating pin).
a
Put two drops of FRENETANCHE (see Vehicle:
Parts and consumables for the repair ) on the
threading of the TDC setting pin hole plug.
a
Torque tighten the TDC setting pin hole plug (25
N.m) .
114432
114433
Note:
Do not fit the pins ( 37 ) of the tool into the holes
on the wear compensation pinion.
Note:
Do not fit the collet ( 34 ) of the tool into the groove
on the exhaust side of the camshaft.
114434