Renault Laguna III, Manual

Page: 520 / 3699

11A
-
142
TOP AND FRONT OF ENGINE
Rocker cover: Removal - Refitting
F4R
11A
a
Use a stipple roller to apply RESIN ADHESIVE (see
Vehicle: Parts and consumables for the repair )
(MR 415, 04B, Consumables - Products) to the rock-
er cover joint face until it is well covered.
a
Refit the rocker cover centring devices using a roll
pin punch and a hammer.
II - REFITTING OPERATION FOR PART
CONCERNED
a
Refit the rocker cover.
a
Fit without tightening the rocker cover bolts.
a
Torque tighten:
- the rocker cover bolts (22), (23), (20), (13) (8
Nm) ,
- the rocker cover bolts (1) to (12), (14) to (19),
(21), (24) (12 Nm) ,
- the rocker cover bolts (22), (23), (20), (13) (12
Nm) .
III - FINAL OPERATION.
a
Refit:
- the lifting ring on the gearbox side,
- the gearbox side lifting eye bolts.
a
Tighten the gearbox side lifting eye bolts.
a
Clip:
- the injector wiring on the gearbox side lifting eye,
- the throttle valve wiring on the gearbox side lifting
eye.
a
Remove the blanking plugs.
a
Connect:
- the fuel supply union to the injector rail,
- the fuel vapour absorber solenoid valve connector.
a
Clip:
- the fuel vapour rebreathing pipe,
- the fuel vapour absorber solenoid valve wiring.
a
Refit:
- the camshaft seals on the timing end (see 11A ,
Top and front of engine , Camshaft seal, timing
end: Removal - Refitting , page 11A-287 ) ,
- the timing belt (see 11A , Top and front of engine ,
Timing belt: Removal - Refitting , page 11A-50 ) ,
14517
WARNING
Applying excess sealant could cause it to be
squeezed out when parts are tightened. A mix-
ture of sealant and fluid could damage certain
components (engine, radiator, etc.).
Note:
Use a cloth to remove any RESIN ADHESIVE in
the rocker cover bearings.
120210