Renault Laguna III, Manual

Page: 2482 / 3699

38C
-
10
ANTI-LOCK BRAKING SYSTEM
Hydraulic brake unit: Removal - Refitting
F4R
38C
a
Remove the bulkhead lower heat shield clips ( 3 ) .
a
Shift the lower heat shield backwards to access the
hydraulic unit.
II - OPERATION FOR REMOVAL OF PART
CONCERNED
a
Disconnect the connector ( 4 ) from the hydraulic unit
computer by lifting the lug ( 5 ) .
a
Remove:
- the brake pipe unions ( 6 ) on the hydraulic unit,
- the bolts ( 7 ) mounting the hydraulic unit on its sup-
port,
- the hydraulic unit.
REFITTING
I - REFITTING OPERATION FOR PART
CONCERNED
a
Refit:
- the hydraulic unit,
- the brake pipe unions on the hydraulic unit.
a
Tighten to torque:
- the hydraulic unit bolts on the support (8 Nm) ,
- the brake pipe unions on the hydraulic unit (14
Nm) .
a
Connect the computer connector on the hydraulic
unit.
II - FINAL OPERATION.
a
Refit:
- the bulkhead lower heat shield,
- the bulkhead lower heat shield clips,
- the catalytic converter (see Catalytic converter:
Removal - Refitting ) (19B, Exhaust),
- the rear suspended engine mounting (see Lower
engine tie-bar: Removal - Refitting ) (19D, En-
gine mounting),
- the engine undertray,
- the bulkhead heat shield,
- the turbocharger heat shield.
a
Remove the pedal press .
a
Connect the battery (see Battery: Removal - Refit-
ting ) (80A, Battery).
a
Bleed the brake circuit (see 30A , General informa-
tion , Braking circuit: Bleed , page 30A-4 ) .
122855
122854