Renault Laguna III, Manual

Page: 1127 / 3699

13B
-
188
DIESEL INJECTION
High pressure pipe between rails: Removal - Refitting
V9X
13B
a
Refit the bolts of the high pressure pipe between the
rails.
III - FINAL OPERATION
a
Refit the vacuum solenoid valve support.
a
Fit the wiring for the heater plugs.
a
Connect the heater plug connectors.
a
Refit the intercooler air outlet pipe.
a
Fit the injector rail protector on the back row.
a
Refit the bolts of the injector rail protector on the
back row.
a
Connect the exhaust gas recirculation solenoid
valve cooling hose.
a
Fit the exhaust gas recirculation solenoid valve hose
clip
(Mot. 1448) using the tool.
a
Refit:
- the injector rail protector on the front cylinder bank
(see 13B , Diesel injection , Injector rail protec-
tor: Removal - Refitting , page 13B-126 ) ,
- the injector rail protector cover on the back row.
a
Clip the injector rail protector cover on the back row.
a
Clip:
- the cooling hose,
- the wiring of the exhaust gas recirculation solenoid
valve.
a
Connect the battery (see Battery: Removal - Refit-
ting ) (80A, Battery).
a
Fill and bleed the cooling system (see 19A , Cool-
ing , Cooling system: Draining - Refilling , page
19A-16 ) .
a
Refit:
- the front bumper (see Front bumper: Removal -
Refitting ) (55A, Exterior protection),
- the front wheel arch liners (see Front wheel arch
liner: Removal - Refitting ) (55A, Exterior protec-
tion),
- the front wheels (see Wheel: Removal - Refitting )
(35A, Wheels and tyres),
- the engine undertray.
a
Prime the diesel circuit using the manual priming
pump.
a
Switch on after ignition.
a
Connect the Diagnostic tool .
a
In the Diagnostic tool :
- select the repair mode,
- select the programming mode,
- select command SC 035: HIGH PRESSURE FUEL
CIRCUIT FAULT FINDING .
a
Check:
- the correct operation of the high pressure fuel cir-
cuit,
- that there are no leaks.
a
Refit the engine cover.