Renault Laguna III, Manual

Page: 269 / 3699

10A
-
192
ENGINE AND CYLINDER BLOCK ASSEMBLY
Lower cover: Removal - Refitting
K9K
10A
a
Degrease the joint face using SURFACE CLEANER
(see Vehicle: Parts and consumables for the re-
pair ) (04B, Consumables - Products) and CLEAN
CLOTHS .
a
parts always to be replaced: engine oil sump
seal (10,03,01,09)
a
Apply:
- two beads ( 8 ) of SILICONE ADHESIVE SEALANT
(see Vehicle: Parts and consumables for the re-
pair ) (04B, Consumables - Products) with a diame-
ter of 5 mm and a length of 12 mm ,
- four drops ( 9 ) of SILICONE ADHESIVE SEALANT
(see Vehicle: Parts and consumables for the re-
pair ) (04B, Consumables - Products) with a diame-
ter of 5 mm .
II - REFITTING OPERATION FOR PART
CONCERNED
a
Fit:
- a new sump seal to the sump,
- the sump fitted with its new seal.
a
Fit without tightening:
- the bolts from the sump on the gearbox,
- the sump bolts on the cylinder block.
a
Tighten to torque the sump bolts on the gearbox
(44 N.m) .
20166
20167
Note:
If the oil pump was loosened beforehand in order
to extract the sump, position the sump in order to
pass the oil pump strainer into the oil splash
plate of the sump.
Position a component jack to support the sump.
Tilt the sump towards the front of the vehicle, in
order to facilitate access to the oil pump bolts.
Torque tighten the oil pump bolts ( 25 N.m ) using
the small torque wrench 77 11 226 888 .
Fit the sump and then follow the following instruc-
tions.
Note:
Before pressing the sump on the cylinder block,
check that the sump seal is still in place and that
it has not come out of the grooves on the sides.