Renault Laguna III, Manual

Page: 2093 / 3699

30A
-
28
GENERAL INFORMATION
Front axle system: Adjustment
30A
ADJUSTMENT PREPARATION STAGE
a
Check the geometry (see 30A , General informa-
tion , Axle assemblies: Check , page 30A-19 ) .
1 - Wheel alignment
a
Adjust the wheel alignment by rotating the track rod
sleeves.
a
Loosen the wheel alignment adjustment lock nut ( 1 )
.
a
Turn the track rod sleeve ( 2 ) to the required value.
a
After adjustment, torque tighten the wheel align-
ment adjustment lock nuts (53 N.m) .
2 - Castor angle
a
Not adjustable.
3 - Camber
a
Not adjustable.
4 - Pivot
a
Not adjustable.
a
Carry out calibration of the steering wheel angle
sensor.
Apply the after repair procedure:
- connect the diagnostic tool,
- select "Braking computer",
- go to repair mode,
- display the "Before/after repair procedure" for the
computer selected,
- select "Steering wheel angle sensor" in the "List of
components controlled by this computer" section,
- carry out the operations described in the "After re-
pair procedure" section.
Tightening torques
m
wheel alignment adjust-
ment lock nuts 53 N.m
Note:
Throughout the axle assembly checking and adjust-
ment process:
- the Renault Card must remain in the reader,
- do not press the « START » button.
122722
ELECTRONIC STABILITY PROGRAM