Renault Laguna III, Manual

Page: 311 / 3699

10A
-
234
ENGINE AND CYLINDER BLOCK ASSEMBLY
Oil pressure sensor: Removal - Refitting
V4Y
10A
REMOVAL
I - REMOVAL PREPARATION OPERATION
a
Position the vehicle on a two-post lift (see Vehicle:
Towing and lifting ) (02A, Lifting equipment).
a
Remove:
- the engine oil filler cap,
- the dipstick,
- the engine undertray bolts,
- the engine undertray,
- the front right-hand wheel (see Wheel: Removal -
Refitting ) (35A, Wheels and tyres),
- the front right-hand driveshaft (see Front right-
hand driveshaft: Removal - Refitting ) (29A,
Driveshafts),
- the lower engine tie-bar (see 19D , Engine mount-
ing , Lower engine tie-bar: Removal - Refitting ,
page 19D-85 ) .
a
Drain the engine (see 10A , Engine and cylinder
block assembly , Engine oil: Draining - Refilling ,
page 10A-100 ) .
II - OPERATION FOR REMOVAL OF PART
CONCERNED
a
Cut the oil pressure sensor connector plastic clip.
a
Remove the rubber protector ( 1 ) from the oil pres-
sure sensor connector.
a
Disconnect the oil pressure sensor connector ( 2 ) .
a
Remove the oil pressure sensor using a 26 mm long
socket.
REFITTING
I - REFITTING OPERATION FOR PART
CONCERNED
a
Refit the oil pressure sensor.
a
Tighten to torque the oil pressure sensor (15 N.m) .
a
Connect the oil pressure sensor connector.
a
Fit the rubber protector to the oil pressure sensor
connector.
Tightening torques
m
oil pressure sensor 15 N.m
135520
Note:
Prepare for the engine oil to drain out.