Renault Laguna III, Manual

Page: 2991 / 3699

88A
-
85
WIRING HARNESS
Passenger's front side door wiring: Removal - Refitting
B91 or K91
88A
REMOVAL
I - REMOVAL PREPARATION OPERATION
a
Raise the window fully.
a
Apply the before repair procedure using the Dia-
gnostic tool :
- connect the Diagnostic tool ,
- select the airbag computer,
- go to repair mode,
- apply the « Before repair procedure » .
a
Switch off the ignition.
a
Disconnect the battery (see 80A , Battery , Battery:
Removal - Refitting , page 80A-4 ) .
a
Remove:
- the front side door trim (see Front side door trim:
Removal - Refitting ) (72A, Side opening element
trim),
- the door sealing film (see Door sealing film: Re-
moval - Refitting ) (65A, Opening element seal-
ing),
- the front side door lock (see Front side door lock:
Removal - Refitting ) (51A, Side opening element
mechanisms),
- the side impact sensor on the front door (see 88C ,
Air bag and Pretensioners , Side impact sensor:
Removal - Refitting , page 88C-27 ) .
a
Disconnect the door mirror connector.
Equipment required
Diagnostic tool
IMPORTANT
Consult the safety and cleanliness advice and oper-
ation recommendations before carrying out any
repair (see
88A , Wiring harness , Wiring: Precau-
tions for the repair , page 88A-4 ) .
WARNING
To prevent damaging the connectors, consult the
disconnection procedure (see
Connector: Discon-
nection and reconnection ) (Technical Note
6015A, 88A, Wiring).
IMPORTANT
To avoid any risk of triggering when working on
or near a pyrotechnic component (airbags or pre-
tensioners), lock the airbag computer using the
diagnostic tool.
When this function is activated, all the trigger
lines are inhibited and the airbag warning light on
the instrument panel lights up continuously (igni-
tion on).