Renault Laguna III, Manual

Page: 109 / 3699

10A
-
32
ENGINE AND CYLINDER BLOCK ASSEMBLY
Engine - gearbox assembly: Removal - Refitting
M9R
10A
REMOVAL
I - REMOVAL PREPARATION OPERATION
a
Position the vehicle on a two-post lift (see Vehicle:
Towing and lifting ) (02A, Lifting equipment).
a
Remove:
- the engine cover,
- the battery (see Battery: Removal - Refitting )
(80A, Battery),
- the battery tray (see Battery tray: Removal - Re-
fitting ) (80A, Battery),
- the diesel injection computer (see 13B , Diesel in-
jection , Diesel injection computer: Removal -
Refitting , page 13B-36 ) ,
- the air filter unit (see 12A , Fuel mixture , Air filter
unit: Removal - Refitting , page 12A-13 ) ,
- the front wheels (see Wheel: Removal - Refitting )
(35A, Wheels and tyres),
- the engine undertray,
- the front wheel arch liners (see Front wheel arch
liner: Removal - Refitting ) (55A, Exterior protec-
tion).
a
Drain the gearbox (see Manual gearbox oils:
Draining - Filling ) (21A, Manual gearbox).
a
Drain:
- the cooling system (see 19A , Cooling , Cooling
system: Draining - Refilling , page 19A-16 ) ,
- the refrigerant circuit using a refrigerant charging
station (see Refrigerant circuit: Draining - Fill-
ing ) (62A, Air conditioning).
a
Remove:
- the front left-hand wheel driveshaft (see Front left-
hand driveshaft: Removal - Refitting ) (29A,
Driveshafts),
- the front right-hand wheel driveshaft (see Front
right-hand driveshaft: Removal - Refitting )
(29A, Driveshafts).
a
Remove the differential output seals (see Differen-
tial output seal: Removal - Refitting ) (21A, Manu-
al gearbox).
a
Remove:
- the engine tie-bar (see 19D , Engine mounting ,
Lower engine tie-bar: Removal - Refitting , page
19D-85 ) ,
- the front bumper (see Front bumper: Removal -
Refitting ) (55A, Exterior protection),
- the headlights (see Headlight: Removal - Refit-
ting ) (80B, Headlights),
Special tooling required
Mot. 1448 Remote operation pliers for
hose clips.
Ms. 583 Pipe clamps.
Mot. 1390 Support for removal - refitting
of engine - gearbox assembly
Equipment required
refrigerant charging station
oil recovery tray
tweezers
Tightening torques
m
earth cables on the side
members 8 N.m
air conditioning hose
bolt on the compressor 8 N.m
air conditioning hose
nuts on the condenser 8 N.m
IMPORTANT
To avoid all risk of damage to the systems, apply
the safety and cleanliness instructions and opera-
tion recommendations before carrying out any
repair:
- (see 1 3 B , Diesel injection , Diesel injection:
Precautions for the repair , page 13B-1 ) ,
- (see Vehicle: Precautions for the repair ) (01D,
Mechanical introduction).
M9R, and 742 or 744 or 746 or 748 or 754 or 800
or 802 or 806 or 808 or 816
M9R, and 742 or 744 or 746 or 748 or 754 or 800
or 802 or 806 or 808 or 816