2515 Bypass Rd. Flemingsburg, KY 41041
606-845-7439
Instructions for Installation and Care of Honda Pioneer 500
Full Cab with Aero-Vent Windshield
HO-P500-FC04
CAUTION: Do not smoke inside the cab or expose the enclosure to direct flames. Product is FLAMMABLE.
Be sure to read these instructions thoroughly before opening and installing. The installation is best done
when the temperature is 70 degrees F. or warmer. The temperature affects the adhesive Velcro, if conditions
prevent installing in warmer weather it helps to store the adhesive Velcro at room temperature prior to
installation.
1.
This cab enclosure is made up of 4 different panels that all come together to enclose the sides and rear of
the vehicle. You may put on different pieces or leave other pieces off to create the enclosure that best
meets your needs.
2.
Check over the parts included in the carton with the parts list shown below:
Velcro hook strips
16 each
3” long
Velcro hook strips
4 each
6” long
Velcro hook strips
2 each
9” long
Velcro hook strips
2 each
34” long
Velcro hook strips
1 each
38” long
Webbing Straps w/Loop
2 each
Webbing Straps w/ Grommets
2 each
Webbing Straps w/ Velcro
2 each
Screw snaps
13 each (1 extra)
Cab enclosure
4 Pieces
If any parts are damaged or missing please contact customer service at (606) 845-7439.
3.
For these instructions we will be installing the entire enclosure. This will cover every piece so if you
should want to install just parts of the enclosure these instructions should be sufficient. The order of
installation will be as follows:
a.
Side Door Panels
b.
Rear Window
c.
Top
Door Panels:
4.
Begin installation by hanging the Door Panels from the top by using the 3” adhesive Velcro strips as
shown in the photos on the next page:
