Mindray Zonare ZS3, Service Manual

Page: 172 / 295

ZS3 Service Manual Page 172 of 295
Use a soft dry cloth to clean the surface of the control panel (including the
keystrokes, encoders and sliders). If the control panel is dirty, moisten the soft
cloth with a little mild soapy water and wipe away any stains. Use another soft dry
cloth to remove any moisture and allow all hard surfaces to completely air dry. If
the control panel is difficult to clean, disassemble the encoder caps first and then
clean it with mild soapy water.
NOTE: The keyboard on the control panel should be cleaned periodically,
otherwise the keys may be blocked with dirt and when the buzzer
rings the keys will not work.
External Case Cleaning
1. Before cleaning, turn off the AC circuit breaker on the ZS3 system to
remove all power from the unit.
2. Wipe the ZS3 system surfaces with a safe disinfectant solution such as
Sani-Cloth Plus or isopropyl 50% alcohol and follow the disinfectant label
instructions for use.
3. Repeat with water moistened soft cloth only.
4. Wipe dry with a clean, dry, soft cloth.
WARNING: Do not expose the external case of the LCD display to any of the
following agents:

Cidex

Betadine
WARNING:

Do not use disinfectants (such as gluteraldahyde or hydrogen peroxide) or
acetone to clean any surfaces on the ZS3 system or its accessories.

Before cleaning, turn off the AC circuit breaker on the ZS3 system to
remove all power from the unit.

Do not autoclave, immerse, or attempt to sterilize the LCD display or
transducers.

Do not spill or spray liquid directly on the control panel, LCD display, battery
charger, AC power adapter, or transducer connector.
WARNING: To avoid electrical shock before cleaning the ZS3 system, turn off
the AC circuit breaker at the rear of the system. Always use protective eyewear
and clothing when cleaning or disinfecting the ZS3 system.

The level of disinfection required for the ZS3 system is dictated by the type
of contaminants the system came in contact with.