Toshiba TMPR4925, Руководство пользователя

Страница: 49 / 590

Chapter 1 Features
1-3
1.2.2 TX4925 Peripheral Circuit Features
1.2.2.1 External Bus Controller (EBUSC)
The External Bus Controller generates necessary signals to control external memory and
I/O devices.
•
6 channels of chip select signals, enabling control of up to six devices
•
Supports access to ROM ( including mask ROM, page mode ROM, EPROM and EEPROM),
SRAM, flash ROM, and I/O devices
•
Supports 32-bit, 16-bit and 8-bit data bus sizing on a per channel basis
•
Supports selection among full speed (up to 80 MHz), 1/2 speed (up to 40 MHz), 1/3 speed
(up to 27 MHz) and 1/4 speed (up to 20 MHz) on a per channel basis
•
Support specification of timing on a per channel basis
•
The user can specify setup and hold times for address, chip enable, write enable, and output
enable signals
•
Supports memory sizes of 1M byte to 1G byte for devices with 32-bit data bus, 1M byte to
512M bytes for devices with 16-bit data bus, and 1M byte to 256M bytes for devices with 8-
bit data bus
1.2.2.2 DMA Controller (DMAC)
The TX4925 contains a 4-channel DMA controller that executes DMA transfer to memory and
I/O devices.
•
4-channel independently handling internal/external DMA requests
(Usable 2 channels by external DMA requests)
•
Supports DMA transfer with built-in serial I/O controller and AC-link controller based on
internal DMA requests
•
Supports signal address (fly-by DMA) and dual address transfers in external I/O DMA
transfer mode using external DMA requests
•
Supports transfer between memory and external I/O devices having 32-/16-/8-bit data bus
•
Supports memory-to-memory copy mode, with no address boundary restrictions
•
Supports burst transfer of up to 8 words for a single read/write
•
Supports memory fill mode, writing word data to specified memory area
•
Supports chained DMA transfer