Toshiba TMPR4925, Руководство пользователя

Страница: 331 / 590

Chapter 10 PCI Controller
10-71
10.4.42 PCI Controller Configuration Register (PCICCFG) 0xD170
31 20 19 16
Reserved GBWC[19:16]
R/W : Type
0xf : Initial value
15 8 7 5 4 3 2 1 0
GBWC[7:0] Reserved
Reserved
HRST SRST TCAR LCFG
R/W R/W R/W R/W R/W R/W : Type
0xff 1 0 0 0 1 : Initial value
Bits Mnemonic Field Name Description
31:20
⎯
Reserved
⎯
19:8 GBWC G-Bus Wait
Counter Setting G Bus Wait Counter (Initial value: 0xfff, R/W)
Sets the Retry response counter at the G-Bus during a PCI initiator Read transaction.
When the initiator Read access cycle exceeds the setting of this counter, a Retry
response is sent to the G-Bus and the G-Bus is released. PCI Read operation
continues. This counter uses the G-Bus clock (GBUSCLK) when operating.
When 0x000 is set, a Retry response is not sent to the G-Bus by a long response
cycle count.
Note: Since the initial value is the same as for the G-Bus timeout count
(TOCNT.GTOCNT), set the value smaller than the G-Bus timeout count value
such as 0xff0 in order to use retry function.
7:5
⎯
Reserved
⎯
4
⎯
Reserved Note: This bit is always set to “1”. (Initial value: 1, R/W)
3 HRST Hardware Reset Hard Reset (Initial value: 0, R/W)
Performs PCI Controller hardware reset control. This bit is automatically cleared when
Reset ends. This is a diagnostic function.
The PCI Controller cannot be accessed for 32 G-Bus clock cycles after this bit is set.
1: Perform a hardware reset on the PCI Controller.
0: Do not perform a hardware reset on the PCI Controller.
2 SRST Software Reset Soft Reset (Initial value: 0, R/W)
Performs PCI Controller software reset control. Also, please use the software to clear
this bit at least four PCI Bus Clock cycles after Reset.
Other registers of the PCI Controller cannot be accessed while this bit is set.
This bit differs from the Hardware Reset bit (HRST) in that the G-Bus Ack State
Machine is not affected. Should be able to R/W any registers. G2P Status Register
1 TCAR Target
Configuration
Access Ready Target Configuration Access Ready (Initial value: 0/1, R/W)
Specifies whether to accept PCI access as a target.
During PCI boot, configuration access can be received from the PCI Bus after all
initialization has completed.
This bit becomes “1” only when in the PCI Boot Mode and the Satellite Mode.
Operation when this bit is set to “1” then reset to “0” is not defined.
1: Responds to PCI target access.
0: Performs a Retry response to PCI target access.
0 LCFG Load
Configuration
Data Register Load PCI Configuration Data Register (Initial value: 1, R/W)
This bit is set to 1 after reset including Hard or Soft reset in PCIC. It can be cleared
only by software.
When this bit is “1”, the value written to the Configuration Data 0/1/2/3 Register is also
written to the Configuration Space Register.
This bit must be cleared by software after load because no PCI config cycles will be
possible until it is cleared.
1: Load from the Configuration Data 0/1/2/3 Register.
0: No Load.
Figure 10.4.42 PCI Controller Configuration Register