Beckman Coulter UniCel DxC 600, Инструкция по эксплуатации

Страница: 463 / 498

A13
9
14
AF
12
-2
5
T
roubl
es
hoo
tin
g
C
a
libr
a
ti
on and
Res
u
lt
E
rr
o
rs
Co
m
m
o
n
Er
ro
r Me
ss
a
g
e
s a
n
d C
o
rr
e
ct
ive
A
ct
io
n
s
12
0x057A000A
4
Tube Too Tall for Cap
Piercing Sample Wheel.
Rack; Cup: CAU: Incompatible Tube Type
Message ID:
0x057A000A
Subsystem: SRShuttle
This error will only occur when the CTS
thinks it has sensed a tube too soon. In
reality, it is impossible to put too tall of a
tube in because of the Gate Top and the
CTS cover. They sit too low to allow any
marginal tube height. • Make sure tubes are approved for use and in
appropriate rack for tube size. Refer to
Sample
Tubes Validated for CTS .
• Make sure rack is designated properly as a 100
or 75 mm rack in the Reserved Rack screen.
Refer to
Assigning or Reassigning Reserved
Racks .
•
Make sure the tubes are seated properly in the
appropriate rack.
• If tubes have been re-capped, make sure caps
are fully seated in the tube.
• If error continues perform cap piercer tube
height alignment.
•
Contact Beckman Coulter Support Center for
additional information.
0x057A000E
4
Rack Height Not
Defined CAU: Rack Height Not Defined
Message ID: 0x057A000E
Subsystem: SRShttl
CTS is installed and the sample rack
does not have a height defined. • Make sure the rack height is defined. Refer to
Figure 2.2, Reserved Racks/Obstruction
Detection Setup Dialog Box
.
0x057B0008
4
Offload Track Is Full
CAU:
Offload Track Is Full
Message ID: 0x057B0008
Subsystem:
SRLdr
This error will occur when the offload
trays sensor has been triggered. This
error is working as designed in most
cases.
•
Unload Racks from the Offload Tray.
•
If track is not full, make sure the switch at the far
right end of the track is not pressed in.
• If the error continues, contact Beckman Coulter
Support Center.
0x05DC0070
4
Instrument Computer
Interprocess Error CAU: Boot Task - Message
Receive Error
Message ID: 0x05DC0070
Subsystem : boot
Err no: errno
Likely cause is a resource issue between
the Instrument computer processes.
There may be a mix-up during file
transfer or a file may be missing. • At the Red Message screen, select Shutdown .
• If the problem continues after the instrument
has been shutdown, contact Beckman Coulter
Support Center for additional information.
Table 12.10 Error Messages and Corrective Actions (Continued)
ID
Class #
Pop-up Event Log Description Corrective Action