Beckman Coulter UniCel DxC 600, Инструкция по эксплуатации

Страница: 151 / 498

A13914AF
4-19
Reagent Load/Calibration
Within-Lot Calibration
4
•
Chem name
•
Reagent Position
MC Subsystem Calibration Failure
The MC Subsystem warns the operator of a failed calibration. If a chemistry fails, a pop-up message
appears after a completed calibrator level. The message includes:
•
Chem name
•
Calibration error
•
Calibrator Name and Level Number
IMPORTANT
Refer to CHAPTER 12, Troubleshooting Calibration and Result Errors for additional information
on Calibration Error messages.
Within-Lot Calibration
Introduction
The Within-Lot Calibration option provides multiple reagent load of cartridges of the same lot
number without having to calibrate each cartridge. The calibration factor established from a fresh
cartridge (less than 8 hours on board the instrument) is stored and applied to subsequently loaded
cartridges of the same lot.
Within-Lot Calibration Frequency
The length of time a within-lot calibration factor remains valid (its within-lot calibration
frequency) depends on the chemistry. During this interval any newly loaded cartridge with the
same lot number will receive the calibration status
Calibrated . At the end of this frequency period,
a new within-lot calibration factor must be established from a fresh cartridge.
The calibration frequency of a particular cartridge has priority over the within-lot calibration
frequency. If a cartridge selected for within-lot calibration is still loaded at the end of its individual
calibration frequency period, that cartridge must be recalibrated (this will not affect the within-lot
calibration factor).
Enable Within-Lot Calibration
The system status must be Standby .
1
Select
Rgts/Cal
from the menu bar.