Beckman Coulter UniCel DxC 600, Инструкция по эксплуатации

Страница: 457 / 498

A13
9
14
AF
12
-1
9
T
roubl
es
hoo
tin
g
C
a
libr
a
ti
on and
Res
u
lt
E
rr
o
rs
Co
m
m
o
n
Er
ro
r Me
ss
a
g
e
s a
n
d C
o
rr
e
ct
ive
A
ct
io
n
s
12
0x02BC1300
4
Photometer Error ( error
message ), Command:
0xcommand , Error
Number: 0xerror
number
CAU: Photometer Error
Message ID:
0x02BC1300
Error Msg: error message
Command: 0xcommand
Error number:
0xerror number
This error occurs when the photometer
fails to successfully read/analyze a
cuvette. There are several types of
Photometer Smart Module (PSM) errors.
If for any reason the instrument "Stops"
while the photometer is trying to read a
cuvette, the photometer will flag an
error. Check the Event Log for any
messages that might indicate a problem
around the same time stamp as the PSM
Error.
Check the Cuvette Center Alignment for
any cuvettes that exceed a 0±6 value.
This will flag a PSM Error.
• Press the STOP button and Home the system.
• Check Event Log for specific PSM subsystem
errors. Refer to
Event Log .
•
Contact Beckman Coulter Support Center for
additional information.
0x02BC2107
4
Failed to Initialize
Photometer CAU: Failed to Initialize PSM
Message ID: 0x02BC2107
The Photometer Smart Module (PSM)
failed to initialize during startup or
homing, the CC side is stopped. • Press the DxC STOP button. Wait for the motors
to release power (about 30 seconds, listen for
the sound of the Smart Modules resetting) then
Home the system.
• If the error continues, contact Beckman Coulter
Support Center for additional information.
0x032B0005
2
CC Obstruction
Detection Transducer
Failure CAU: CC Obstruction Detection
Transducer Failure
Message ID:
0x032B0005
Subsystem:
rasdSmc
This error usually occurs whenever the
obstruction transducer does not see fluid
during runtime. Often this comes from a
clogged degasser or lack of Degassed
water to the system. The obstruction
detection transducer is looking for a
certain range of pressure during its
primes before sample aspiration. If it
does not see the correct differential, it
will flag a transducer error. • Check Obstruction Detection Transducer for
obvious leaks or dripping from connections or
the device itself and CC Sample Probe.
•
Check for pinch in Water line (from syringe to to
top of probe).
•
Make sure the CC sample Syringe is properly
seated.
• Make sure CC Sample Probe tubing is properly
connected at top of Probe. Refer to Step 3-4 of
the procedure.
•
Contact Beckman Coulter Support Center for
additional information.
Table 12.10 Error Messages and Corrective Actions (Continued)
ID
Class #
Pop-up Event Log Description Corrective Action