Beckman Coulter UniCel DxC 600, Инструкция по эксплуатации

Страница: 454 / 498

A13
9
14
AF
12
-1
6
Tro
u
blesho
o
ting Cal
ibr
a
tio
n a
n
d Result
E
rro
rs
Comm
on Er
ro
r Me
ss
ages
and
C
o
rr
ec
tiv
e
Act
ion
s
0x02620036
4
Level sense error in one
or more cartridges CAU: Level sense error in one
or more cartridges
Message ID: 0x02620036
Subsystem: RASched
This error occurs when the reagent
probes were unable to detect fluid in a
selected cartridge or cartridges during a
reagent load. One attempt by each A
and B reagent probe is made to level
sense and resulting levels are then
compared for accuracy/consistency. • Unload the reagent cartridge and inspect to see
if there are any bubbles in the cartridge
compartments, or residual fluid on the sidewalls
of the openings of the cartridge compartments.
This could cause false triggering of the level
sense. Refer to
Load/Unload Cartridge
Chemistries (CC) .
• Cartridge must be reloaded to initiate level
sense.
• Check reagent probe alignment for any residual
fluid in wash collar.
Consistent messages may indicate issues with the
level sense function of:
• reagent probe bead assembly
• reagent probe alignments
• level sense board
Contact Beckman Coulter Support Center for
additional information.
0x0262003A
4
CC Sample Probe
disabled due to
obstruction errors CAU: CC Sample Probe
Disabled Due To Obstruction
Errors
Message ID: 0x0262003A
Subsystem: ccScheduler
Multiple samples had Obstructions
(Clots). • Try flushing probe from the top. Refer to Flush
the Sample and Reagent Probe .
• Perform the CC Sample Probe Alignment
(Calibration). Refer to Step 3 of the
Replace the
Sample and Reagent Probe procedure.
• Replace probe. Refer to Step 3 of the Replace
the Sample and Reagent Probe procedure.
0x0262003F
4
Too many tubes not
venting correctly,
sampling for the CC
probe will be stopped CAU: CC Sample Probe
disabled due to Excess Vacuum
Errors
Message ID: 0x0262003F
Subsystem: ccScheduler
Multiple tubes had excessive vacuum in
thick stopper closed tubes. CC Sample
Probe Disabled. • Check cap piercer for broken blade. Refer to
Replace CTS Blade/Wick (1-Blade Thick CTS
Option)
or Replace CTS Blade (1-Blade Narrow
CTS Option) to inspect the blade.
• Perform CC ODC Alignment.
Table 12.10 Error Messages and Corrective Actions (Continued)
ID
Class #
Pop-up Event Log Description Corrective Action