LEGRAND Raritan PX3TS, User Manual

Page: 553 / 911

Chapter 9: Using the Command Line Interface
533
Interface Description
all Show the IP-related configuration of all interfaces.
Tip: You can also type the command without adding
this option "all" to get the same data. That is,
show
network ip interface .
IPv4-Only or IPv6-Only Configuration
To show IPv4-only or IPv6-only configuration, use any of the following
commands.
Tip: To show both IPv4 and IPv6 configuration data, see IP Configuration (on
page 532).
To show IPv4 settings shared by all network interfaces, such as DNS and
routes:
# show network ipv4 common
To show IPv6 settings shared by all network interfaces, such as DNS and
routes:
# show network ipv6 common
To show the IPv4 configuration of a specific network interface:
# show network ipv4 interface <ETH>
To show the IPv6 configuration of a specific network interface:
# show network ipv6 interface <ETH>
Variables:
•
<ETH> is one of the network interfaces: ETH1/ETH2 , WIRELESS , or BRIDGE .
Note that you must choose/configure the bridge interface if your PX3TS is
set to the bridging mode.
Note: In the bridging mode, only the IP parameters of the BRIDGE interface
function. The IP parameters of ETH1/ETH2 and WIRELESS interfaces do NOT
function.