LEGRAND Raritan PX3TS, User Manual

Page: 152 / 911

Chapter 6: Using the PX3TS
132
To retrieve the "IPv4" address on PX3TS:
1. Press the MODE button to enter the Device mode, indicated by an
alphabet "d" at the top left of the display.
2. The LCD display cycles between the four octets of the IPv4 address,
indicated by "i4" at the upper right corner of the display.
For example, 192.168.84.4 cycles in this sequence:
192 --> 168 --> 84 --> 4
MAC Address
This product's MAC address is retrievable by operating the LCD display.
Below illustrates the MAC address information.
Section Example information
"d" means the LCD display has entered the Device mode.
"M" indicates that the displayed information is the MAC
address.
"MASTER" indicates the PX3TS is the master device in a
cascading chain.
For a slave device, it shows "SLAVE" instead.
Note: "MASTER/SLAVE" information is only available in Port
Forwarding mode.
The LCD display is showing "03," which is part of the MAC
address.
To display the MAC address:
1. Press the MODE button to enter the Device mode, indicated by a 'd' in at
the top left of the display.
2. Press the FUNC button until the MAC address is displayed. The character
"M" appears in the left side of the LCD display.
3. The MAC address is displayed as "M:XX", where XX are two digits of the
MAC address. The LCD will cycle through the MAC address from the first
two digits to the final two.